Parts of Press Valve

No.1 Holes in which fixing stabs that fix the
        main body of the machine to the lower
        plate of the sink.
No.2 Faucet that is installed on the sink
No.3 Head from which water flows out
No.4 Pedal on which you step to operate the
        machine
No.5 Hose that connects hot and cold water     
        valves installed on the wall behind the
        sink to the main body of the machine
No.6 Fixing Bolts that are stuck into No.1parts
No.7 Nuts that is attached to the hose
        connected to the No.3 part to connect 
        the hose with the joint
       (No.3) on the center of the back of the   
         Machine body.

1) Bore a hole in the upper plate of the sink to set up the faucet.

2) Make the hose connected to the head pass through the aucet and assemble them.

3) Stick No.2 into the hole bored in the upper plate and assemble the parts in good order

    and set up it.

4) Connect the hoses onnected to the hot and cold water valves on the wall into the holes on the left and right Side Of  the machine body.
(With the red on the pedal connected the hot water valve, and with the blue connected the cold water valve.)

5) In the hole in the center, connect the hose that hangs down from the faucet fixed on the sink.

6) When the position of the machine body is fixed, stick the fixing rubber stabs into it and screw up the nuts so that the rubber can fixed on the upper plate of the sink.

7) Cut the mop hanger with a saw as in diagram and fix it into the pedal.